RATCHETING ARMS: When pulled, activate the clamps to secure your board
RELEASE TRIGGER: When pulled, releases the clamps to free up your board
SWIVEL KNOB: When pulled, enables the rack to be swiwel interior, exterior, or towards stern.
ClampForce™ 3.0 board racks
Safety, Install, and Operation
Safety
ALWAYS CLAMP: Never drive boat with boards unclamped in the board racks.
PROPERLY CLAMP: Always securely clamp boards with both ratcheting arms.
VERIFY CLAMP: Always physically verify the secureness of the board after clamping.
NO HYDROFOILS: Never use this rack to hold hydrofoils.
STOW WHEN DOCKING & TRAILERING: Always swivel the racks inside the boat when docking or trailering.
VIDEO: Watch the video tutorial above before install and operation.
Install
INSTALLATION REQUIRES MOUNTS (not included): To assemble the board racks to your tower you will need mounting hardware. These “mounts” are custom to each tower model.
HOW DO I KNOW IF I NEED MOUNTS: Most new wakeboat towers already have mounts that are compatible with ClampForce 3.0 racks. Use the FindYourMount tool below.
INSTALL IS EASY: Once you have the correct mounts all you’ll need is a set of allen wrenches to install.
Operation
CLAMP: Pull the ratcheting arms to clamp your boards into place.
RELEASE: Pull the release trigger to release your boards.
SWIVEL: Pull the swivel knob and rotate assembly to swivel the racks interior, towards stern, or exterior .
VIDEO: Watch the video above for the full tutorial.